Panic Bar Hardware on Chain Link Gates

This instruction manual for panic bar hardware is taken from this site, where you can find more information or buy it online.

Install mounting plate to inside of gate by using six tek-screws.

Install subassembly onto mounting plate using outside holes for screws. Subassembly should be 2 1/2" from edge of plate.

Depress push pad and install exit bar on back plate subassembly.

Install cover.

Install back cover using sheet metal screws or 1/4" x 1" machine screw with nut.

Adjust so that exit bar latch hits strike.

After latch bracket is adjusted properly, attach to post with tek-screws.

Receiver must act as a gate stop.